The Extended Angled Stern Mount Installation Kit is often used to allow the Smart Thruster to slide between the swim step and the tender at an angle. The bottom fitting is mounted near the aft edge of the swim step, and the top fitting is mounted near the top of the stern's transom.

This Track Assembly is for boats with a swim platform greater than or equal to 12-inches above the water.

Each installation kit includes a basic set of 316 Stainless Steel hardware, matched to your Track Assembly to install the system. It does not include marine adhesive sealant.

The Extended Angled Stern Track Assembly installation kit includes:

• Lower mounting base and hardware

• Upper mounting point and hardware

• Pulley, harness, and line

Every DOCKSTAR Smart Thruster Track Assembly and installation kit is custom built here in beautiful Kingston Washington, USA to match you and your boat's needs.

Instructions for installing this Track Assembly are found at the link below.

We do not take online orders without first discussing the installation approach. Once an approach has been determined, we will then gladly accept your order. Our goal is to assist the boat owner to achieve an easy to install thruster that will enhance the safety and enjoyment of their boating.

Please contact us at info@dockstarthrusters.com to discuss your boat.